Today, Corpus Christi Marina had its Boat Parade, in which Frank took part by not participating, thus keeping the average quality high. Boats motor past the assembled throng beautifully illuminated with Christmas lights aloft.
I did not watch because I have been fixing Frank’s mandatory and domestic lighting.
When the mast was stepped for the keel refit, the rigger cut the wires for lights, wind instrument and the vhf co-ax. I ran a new (thicker, better) co-ax down the mast, topped with a better antenna from Vesper Marine, a Kiwi company. The antenna is attuned to the Vosper Watchmate AIS transponder as well as supporting the VHF and AM/FM/SWB radio.
To get from the boatyard to Corpus Christi marine I rigged up a temporary connection for the VHF and navigation lights. So finally, I have fixed things properly.
The mast light that was fitted when I bought Frank was an LCD tri-light, and it soon failed. So I replaced it with a combo tri nav light and anchor light. The light is changed between modes (navigation and anchor) by reversing the polarity. Not having the right switches at the lighting panel, I jury rigged a toggle switch where the cable from the mast joined the cables to the power. In the heads. Not very elegant but it worked.
I have moved the toggle switch to the control panel, making things much tidier and easier.
The running light and spreader light are rather odd, in that the yellow/green wire is live, as is the brown one. One for each light. I am not sure why the spreader light is so named, as it illuminated the foredeck from below the spreaders. Anyway, after some trial and error, which seemed to indicate a short somewhere either in the mast or between power switch and junction box, I wired them too. No short.
Next was the interior. One twist light (rotate the cover to turn off and on) has disintegrated inside – I might scavenge from an unused light in the locker. Another turned itself on and off at random, and I have fixed that. Both port and starboardlight circuits are now working, but I need to replace a couple of bulbs (lcd).
The Bow navigation light was another jerry rigged patch. The original had given up the ghost, and the wiring in the chain locker was rotten. So, back in Gosport in 2014 I installed a new light. The original wire is hard mounted into the fiberglass and is routed between the inner and outer hulls, so totally inaccessible, as well as rotten. So I ran a new wire to a switch that I installed in the front V berth. Not very practical but it did the job.
Happily, I found some good, unused wires that run from the control panel to the heads – live, negative and earth. I used the earth for the mast light and the +ve and -ve ones to run power from the nav light switch at the control panel to the bow light.
I have lost power to the light of one compass, but that can be remedied later.
So I no longer need to head to the heads to set the navigation lights!
As a special treat, I polished the kettle “as new”, so it is a joy to use on the newly polished stove.
Next I have to decide what to do with the log, which is rigged above the chart desk, because I did not want to cut the co-ax cable in order to thread it through the boat up to the binacle.
Then I will tidy up the electrics at the chart desk. Lost more to do, but making progress…