The Iridium Pilot sits atop the pole.
It has taken so long that I have mislaid two ground cables (where can they be, in a 35 foot boat??), but it feels like a major achievement to actually have it installed.
Next week I will set up the BDE (Below Deck Equipment) and put some money on the SIM, to test the phone and internet.
The wind vane of the Hydrovane steering system looked like being a pain to assemble, so it has languished in its box until today, when ai decided to give it a go.
It is a nylon envelope which is stretched taut over an aluminium (English spelling) frame, and the open end is then laced up “like a corset”, as the instructions say.
I followed the instructions (an unusual event) – liberal sprayings of silicone spray playing their part – and have almost finished.
The stubby vane is now below decks, left overnight to stretch to fit. I will remove the zip ties in the morning and tidy up the corset strings.
Imminent. Impending. Fast approaching.
I have a busy few weeks coming up. Finish the holding tank installation, finish the satcom & radar pole struts, to keep them attached to the stern and stable.
Service the winches. Buy an IPIRB, get the hull scrubbed and anti fouled, new anodes, fix the shaft play and sort the rudder out.
Provisions. Work out how to securely store the water and diesel. Clean the diesel tank and fix the webasto (fuse).
First Aid kit. As Captain I can buy drugs! Get the AloftAlone kit working, and get up the mast a few times – check the mast instruments, trilight and install the camera aloft. Rig the video recorder.
Solar panels for backup power gen. Update the echarts on the Garmin chart plotter and my Garmin iPad app. Make sure I have satcom for email etc all configured, plus phones (Iridium and backup IsatPhone).
Plot courses with emergency ports of call, look at weather patterns. Finish rigging up the HydroVane. Work out some sun protection. Weather seal that port which leaks onto the chart table via the light!
Gary Stainless has completed the crossbar, which Geoff helped him install.
The Iridium dome will sit atop the pole, some 10 feet aloft. I need to get some extra bracing to hold both the satcom pole and radar pole firmly in place, but major progress!
Once I have the satcom BDE (Below Deck Equipment) wired up to the ADE (yes, Above Deck Equipment), I can work on the solar panel placement.
Currently I am testing GRIB programs for weather forecasting.
Also, I am working with Aloft Alone to get some kit on the boat and learn how to use it. More anon…
In the process of installing a holding tank, I had to scrub out the heads. It turned out cheaper to but a new loo than to replace the seals and valves.
Frank has a Raytheon Autohelm, which is integrated to the GPS and allows a course to be held and modified. It was upgraded by the previous owners from a device which controls the tiller to a ram which is connected to the rudder quadrant.
These devices are not good for sustained use, because of their power consumption and inability to work under pressure in heavy seas. Besides, it is a bit flakey, and the wiring came undone halfway through my sail to Gosport.
Whilst I have fixed it, this is not a good solution for long distance sailing. So I invested in a Hydrovane, more info here
Craig Grantham, who rebuilt the engine, installed it, with a little help from me. Pics below.
The Hydrovane requires no electrical power: it have a wind vane (a sail) above the water, and a rudder below water, and it uses these to keep the boat at a set angle to the wind. It was a big investment, but I think it will pay off by taking the strain of driving Frank across the Atlantic. Most customers report that their Hydrovane does 90% of the work!
Polished and buffed, Frank at home. The new lifelines should be done Friday Jan 31st.
I need to add her number and name in a permanent place, to satisfy the new registration with the IoM per the carving.
Kemps are doing the dodgers – changing the name to Frank, matching typeface. Lots more to do, but I am looking forward to seeing her.
The new Culet branding looks great!